UV Curing lamp for use with PIKETREK Mr. Bond UV curable resin.

Mains operated 220-240 volts / 110-130 volts AC power supply required. 9 watt power consumption.

HAVE YOU SEEN THE LIGHT YET?!!!!

Apply Mr. Bond U.V. resin to the desired part of the fly and expose it under the lamp. The light source hardens the resin in a few seconds. Miraculous!

To fill large holes or gaps, fill in a bit at a time and expose under the lamp till hard, normally a few seconds, and then continue adding more until full. This method saves any "blobs" of un-cured resin forming lumps and bumps and spoiling the finish.

Varnish over the top with normal fly-tying varnish, or simply leave your fly for around ten minutes to half an hour under the lamp until the resin has completely cured and acheived maximum strength, job done. Perfect results every time!

A fast, effective way to cement heads , with a great durable epoxy-type finish. A revolution in fly-tying!

Mr. Bond can be "thinned" by warming the bottle in warm water for a few minutes, or "thickened" by putting the bottle in the fridge for a short time......simples!

Mains operated 220-240 volts/110-130 volts AC power supply with 9 watt power consumption. Supplied fitted with English-style plug, overseas customers can replace the mains plug or use the correct adaptor. I have some of these adaptors which I can supply for free for overseas customers if required.

The bulbs in these lamps last a long time but should you need a spare bulb we have them available at £2.50 each, please email me if you need one!

SAFETY WARNING! Although 9 watts does not sound very powerful, do not gaze into these lamps for any length of time, as Ultra-Violet light can damage your eyes. It is an extremely powerful form of light and can give you a nasty case of "welding-flash"!